Seems like the model calls for a 310mm X gantry extrusion .. seems like my Ender 3 v2 uses a 350mm one there.
I'm reluctant to cut it (since once its done there is no going back there ;) .. really gotta get all my parts assembled and ready before I do this next step .. was hoping I was going to be able to be a bit gradual, but this one part seems to require a permanent modification.
It seems like the whole design depends on that extrusion being a but shorter than its wide so it seems like its kind of key to note that for folks.
The instructions should include something about potentially needing to do this :)
Seems like the model calls for a 310mm X gantry extrusion .. seems like my Ender 3 v2 uses a 350mm one there.
I'm reluctant to cut it (since once its done there is no going back there ;) .. really gotta get all my parts assembled and ready before I do this next step .. was hoping I was going to be able to be a bit gradual, but this one part seems to require a permanent modification. It seems like the whole design depends on that extrusion being a but shorter than its wide so it seems like its kind of key to note that for folks.
The instructions should include something about potentially needing to do this :)
Perhaps in the wiki around the frame section.