search

bout100 / er9x

Automatically exported from code.google.com/p/er9x
0 stars 0 forks source link

problem with pot3 only to value high or low #693

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1.change pot3 to switch 3 position
2.setup Chanel 6 to output pot3
3.when you move switch you have to value high,high,
low
But as you can see on pictures value is changing 
Low 0000
Mid 03fc
High 07fe
So switch works in diagnostics mode, and also check voltage on switch and have 
0v,2.5, 5v
Servo only moves two position.
On the another screen with bars pot 3 move bar high or low only. So must be 
some glitches in firmware or my setting in wrong.
What is the expected output? What do you see instead?
Low mid high

What version of the product are you using? On what operating system?

V1.5643-erez

Please provide any additional information below.

Original issue reported on code.google.com by wojte...@yahoo.com on 16 May 2012 at 2:11

Attachments:

GoogleCodeExporter commented 9 years ago 
The pots are included in the calibration operation. Try re-calibrating, put the 
switch in the centre for the mid-position, then when moviing the sticks/pots, 
switch both ways.

Original comment by michael....@mypostoffice.co.uk on 18 Jul 2012 at 5:34

GoogleCodeExporter commented 9 years ago 
Did the re-calibration fix this?

Original comment by michael....@mypostoffice.co.uk on 14 Dec 2013 at 12:29