boweeble / arducam-osd

Automatically exported from code.google.com/p/arducam-osd
0 stars 0 forks source link

Either Video and no overlay OR unplug Fatshark cam and see grey screen with OSD #82

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago
What steps will reproduce the problem?
I flashed the latest firmware 2.0 successfully as well as configured the OSD 
successfully, so I dont think that is the problem. As for my FPV setup: I have 
the Fatshark Predator V2 system, including the fatshark 600tvl camera and I am 
using an Immersion 600mw VTx instead of the supplied 250mw that came with the 
goggles. They are both Immersion, connections are exactly the same. I'm using 
APM 2.5. The Minimosd sent to me came WITH the 5v Jumpers SOLDERED, so i 
started by powering both sides of the board with the 5v from the APM. I have 
since removed the solder from jumpers and am now powering from the 3s Lipo 
EXACTLY as depicted here:

https://code.google.com/p/arducam-os...dware_Diagrams 

Here is the issue: When everything is connected as depicted, i get video from 
the fatshark camera (NTSC), but NO OSD OVERLAY (also set to NTSC). If I unplug 
the camera feed from the OSD board, I then get a grey screen with the MinimOSD 
overlay and functioning telemetry, Attitude compass altitude heartbeats etc are 
working perfectly. ( Battery voltage and rssi aren't working but thats for 
another day. ) Also worth mentioning: When i pull the video input from the 
board and when i see the OSD overlay, I get a strange "strobing" effect where i 
can see the Warning Message just above the horizon for a split second and it 
blinks in and out. The configuration I have loaded to the board for that screen 
should display Warning Messages, so I should see "Disarmed" steadily but I do 
not. I have the camera set to NTSC as well as the OSD. I have searched high and 
low for a solution to this issue and no one has one. I haven't seen anyone with 
this reported problem get it solved. I believe one person got a new board and 
that solved it, others have reported new boards and same problem. Any ideas of 
what the problem is would be very welcome.

What is the expected output? What do you see instead?

What version of the product are you using? On what operating system?

Please provide any additional information below.

Original issue reported on code.google.com by Stbright...@gmail.com on 23 Jan 2014 at 4:19

GoogleCodeExporter commented 8 years ago
bump

Original comment by nee...@gmail.com on 7 Mar 2014 at 11:47

GoogleCodeExporter commented 8 years ago
That seems to be a typical sync issue. When you pull out the video it does work 
because the OSD switch to the internal sync.

Double check if the camera is NTSC or PAL.
Two other guys did it on their 600tvl cameras, as you can see here:
http://diydrones.com/forum/topics/help-fatshark-600tvl-cmos-camera-minimosd-prob
lem?commentId=705844%3AComment%3A1480393

Original comment by sbeni...@gmail.com on 8 Mar 2014 at 11:26