Faders are resisting

[RayesMusic]

Hello! I've been using your script for my X-touch for a few months now. And it always worked. But, recently, I just bought a new MIDI controller... Since I started using it, the xtouch never worked normally again, even after resetting everything and removing the other device. I never changed any settings.

The problem is: -The faders are resisting to my movement in every situation, even in the "free mode" impossible to use it then.

What I tried: -Updating the xtouch firmware -Trying in others DAWs -> works perfectly -Trying the official Mackie control script from Image-Line -> Still the same problem -Trying to delete the USB bus port in Windows settings and reinstall those -Trying to change the UBS cable, and plugging it in different USB ports -Fully re-install FL STUDIO with stock settings

I was thinking that maybe disabling the motors will change something... but I don't know how

I have no idea what is going on, or if it's your script or not. If you have any suggestion, or ideas, it would save my life!

Regards, RAYES

[bramdebouvere]

Hey there,

Since the official Mackie control script seems to have the same issue, I doubt that the script will be to blame.

Perhaps the issue lies in one of the following?

• Incorrect port number on in or output? (might have changed when you added the new midi controller)
• Software from your new MIDI controller interfering with the MIDI info?

I'd suggest checking these out. Please let me know if you're able to fix the issue?

I cannot tell for certain what's wrong. Perhaps it's also worth it to check if you get any errors in the View -> Script Output window?

[RayesMusic]

Hey, thank you for your answer!

I have the MIDI assignments in FL STUDIO which are set as in the instructions. As for the external midi controller software, it's plug and play and I uninstalled the software associated with it.

it's an incomprehensible problem that I've been struggling to solve for more than two weeks.

I also checked in FL STUDIO if the script output was correct an it is. I think i will try the setup on another computer to see if it solves the problem.

I'll keep you informed if i find a solution,

RAYES

[bramdebouvere]

Good luck!

[bramdebouvere]

@RayesMusic any luck getting it to work?