Open consolecwby opened 2 years ago
Does this config file actually work? The klipper FAQ has a section My TMC motor driver turns off in the middle of a print Short answer: Do not use the TMC2208 driver in “standalone mode” with Klipper!
The creality board uses TMC2208 and this config seems to do it in stnadalone since i do not see a UART section.
Hi, I've already replaced that board with an SKR 1.3, so I'm unfortunately not able to test.
Does this config file actually work? The klipper FAQ has a section My TMC motor driver turns off in the middle of a print Short answer: Do not use the TMC2208 driver in “standalone mode” with Klipper!
The creality board uses TMC2208 and this config seems to do it in stnadalone since i do not see a UART section.