Issue while flashing, got stuck

[abdmrknjc]

Hello, I have an issue regarding flashing, was flashing full flash unlocked method BIN file extracted from frf, and it got stuck at the end, SETUP finalizing, now I dont have comms on VCDS, no response from ecu, tried unlocking it again, first time unlock went fine, flashed normal frf, car started etc... Help please flash.log flash_details.log udsoncan.zip

[bri3d]

The last file you flashed looks like it had some kind of modification made in the application software area based on the logs, I think you may have a real brick. Did you try to apply some kind of software patch to this BIN?

On Fri, May 5, 2023 at 12:06 PM Abdullah Mrkonjić @.***> wrote:

Hello, I have an issue regarding flashing, was flashing full flash unlocked method BIN file extracted from frf, and it got stuck at the end, SETUP finalizing, now I dont have comms on VCDS, no response from ecu, tried unlocking it again, first time unlock went fine, flashed normal frf, car started etc... Help please flash.log https://github.com/bri3d/VW_Flash/files/11408545/flash.log flash_details.log https://github.com/bri3d/VW_Flash/files/11408546/flash_details.log udsoncan.zip https://github.com/bri3d/VW_Flash/files/11408553/udsoncan.zip

— Reply to this email directly, view it on GitHub https://github.com/bri3d/VW_Flash/issues/95, or unsubscribe https://github.com/notifications/unsubscribe-auth/AABTO2PPVKJOBD6ZYXTAWIDXEUXS3ANCNFSM6AAAAAAXXLX3N4 . You are receiving this because you are subscribed to this thread.Message ID: @.***>

[abdmrknjc]

I checked file in WinOLS editor, provider edited more than calibration area, it was just supposed to be stage 1 tune, but I saw it, tried getting back to re-lock etc, but no success, it just stays there at entering diagnostic session after compressing FRF file

[FirewinX]

give it a try to flash with odis. when the flash session starts you make a ignition change. i have with this a ecu recovered but a DCM 6.2V