search

bruhautomation / ESP-MQTT-JSON-Multisensor

(OBSOLETE) ESP MQTT JSON Multisensor for Home Assistant. Supported sensors include the TEMT6000 light, AM312 PIR, DHT22 temperature/humidity sensors. RGB led supports flash, fade, and transition. Over-The-Air (OTA) uploading, too!
https://youtu.be/jpjfVc-9IrQ
Apache License 2.0
340 stars 152 forks source link

Contast reboots #61

Closed therains closed 5 years ago

therains commented 5 years ago

I have been using these sensors for the past year and have gone to flash another today and am seeing constant reboots, i tried this on two different chips any idea what the issue may be ?

load 0x4010f000, len 1384, room 16 tail 8 chksum 0x2d csum 0x2d v614f7c32 ~ld calibrating sensor Starting Node named sensornode1

Connecting to xxxxxxxxxxxxxxxxxxxxxxxx ..... WiFi connected IP address: 192.168.1.105 Ready IPess: x Attempting MQTT connection...connected Setting LEDs: r: 0, g: 0, b: 0 {"state":"OFF","color":{"r":255,"g":255,"b":255},"brightness":255,"humidity":"0.00","motion":"","ldr":"0","temperature":"0.00","heatIndex":"nan"} {"state":"OFF","color":{"r":255,"g":255,"b":255},"brightness":255,"humidity":"0.00","motion":"standby","ldr":"0","temperature":"0.00","heatIndex":"nan"} resettin⸮ ets Jan 8 2013,rst cause:2, boot mode:(3,2)

load 0x4010f000, len 1384, room 16 tail 8 chksum 0x2d csum 0x2d v614f7c32 ~ld calibrating sensor Starting Node named sensornode1

consolacion commented 5 years ago

often that is a psu problem. I presume you checked the other thread on the subject?

therains commented 5 years ago

Downgraded ide to the version the previous chips where flashed on. Same port/cable . Resolved my issue..