search

brutella / hkcam

Open-Source HomeKit Surveillance Camera
https://hochgatterer.me/hkcam/
Apache License 2.0
925 stars 141 forks source link

Increase camera hole in lid to work with camera module v1.3 #28

Open brutella opened 5 years ago

brutella commented 5 years ago

It seems like the camera hole is too small for the camera module v1.3 to fit in.

brutella commented 5 years ago

After checking it my v1.3 camera module, it seems like the camera cable on the PCB is shorter by ~1mm compared to the v2.1.

I was able to make it fit by cutting the bottom corners of the PCB with a scissor. This moves the camera module more to the bottom in the enclosure body.

v1 3

laposheureux commented 5 years ago

Had to do the same, the holes don't end up lining up perfectly as a result which makes it hard to close the case flush, but I did get it to snap together.

schwabmario commented 4 years ago

You can also move the camera hole a millimeter higher in your 3D program and then it should fit. The width of the hole is correct.