Hi, thanks for the library, it's very simple and intuitive.
but I have the following doubt:
I have an arduino uno and a gsm shield, I have the following working configuration using the arduino IDE and c++ library:
I connect the tx and rx ports of the gsm shield to ports 10 and 11 of the arduino and use the softwareSerial library to allow serial communication on ports 10 and 11.
because the default arduino ports 0(rx) 1(tx) is being used by serial usb. can I do this same process with go-serial? because I didn't see any example in the documentation. Thank you very much in advance!
Hi, thanks for the library, it's very simple and intuitive. but I have the following doubt:
I have an arduino uno and a gsm shield, I have the following working configuration using the arduino IDE and c++ library:
I connect the tx and rx ports of the gsm shield to ports 10 and 11 of the arduino and use the softwareSerial library to allow serial communication on ports 10 and 11.
because the default arduino ports 0(rx) 1(tx) is being used by serial usb. can I do this same process with go-serial? because I didn't see any example in the documentation. Thank you very much in advance!