Controller web page and display uses wrong units

buildbotics / bbctrl-firmware

Buildbotics CNC Controller Firmware

https://buildbotics.com/

Other

67 stars 24 forks source link

Controller web page and display uses wrong units #255

Open kwince opened 4 years ago

kwince commented 4 years ago

if the unit is set to have imperial units in the settings page, it's still boots up with millimeters in the display and metric in the web page. Versions xx.xx.11 and later. Did not check previous.

If the settings are set to imperial it should display imperial immediately upon boot before any G20 or G21 are executed.IMNSHO

goldino commented 3 years ago

This issue was first raised back in 2019 as issue #206 but is still not fixed. Are you planning to fix this?