buildbotics / bbctrl-firmware

Buildbotics CNC Controller Firmware
https://buildbotics.com/
Other
67 stars 24 forks source link

Z-Axis does does not stop from Jog tab #279

Closed DougCoffland closed 3 years ago

DougCoffland commented 3 years ago

When jogging from the "Jog" tab and not in step mode, the Z axis continues to run after the button is released. This does not seem to happen on the X or Y axes. I am reopening a previous issue where I misunderstood that this problem occurred when not in step mode. This problem does not occur from my local touch screen monitor. It only occurs from my tablet.

I have simulated this problem in my lab. It happens on both the Chrome and Silk browsers on my tablet. It does not happen with the local touch screen monitor. I found that the problem happens consistently with the Chrome browser, but only occasionally with the Silk browser. I also found that if you tap the jogging ring again while the axis is stuck moving, it stops moving. I also found that the problem does not occur if you just tap the axis, but rather hold it down for a bit. It seems to miss the button release. Another symptom is that the word "Fine" becomes highlighted. I also noticed that part of the jogging rings also become highlighted. I am using version 85.0.4183.101 of Chrome on an Amazon Fire tablet.

DougCoffland commented 3 years ago

Fixed in 0.4.15