Closed myerswoodshop closed 3 years ago
Check your post processor. In fusion the default post M6 tool change ads a clearance height move to any tool change.
i think the variable is zRetractHeight
On Thu, Oct 15, 2020, 5:40 PM myerswoodshop notifications@github.com wrote:
Using the same file without the m6 it will not give the error. Possible simulation bug? File will run however.
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/buildbotics/bbctrl-firmware/issues/280, or unsubscribe https://github.com/notifications/unsubscribe-auth/AMCJROG6YMCUCZWRJJHMVJLSK5T4HANCNFSM4SSRC46Q .
Using the same file without the m6 it will not give the error. Possible simulation bug? File will run however.