http://fritzing.org/forum/thread/2270/
from amundsen:
"I suppose I am not the only one using Fritzing to create PCBs with components
connected with headers. With microcontrollers and breakout boards, one does not
always use all the connections. It means unused connections could be left
unconnected, which helps leaving some points to let traces go through.
However, Fritzing's current implementation doesn't allow to mask a connector's
copper to be masked in the PCB view. One has to re-build a board's pinout using
generic female header.
For instance, see on the linked picture what I have done for an Arduino Pro
Mini in a situation where A4/SDA and A5/SCL pins were needed while RST and A3
were not.
http://flic.kr/p/mcWr4r
It would ne nice if Fritzing had an option to remove any pin from PCB view so
to allow this without having to rebuild a component using headers."
Original issue reported on code.google.com by andre.knoerig@gmail.com on 19 Mar 2014 at 1:51
Original issue reported on code.google.com by
andre.knoerig@gmail.com
on 19 Mar 2014 at 1:51