Nixie tubes - Githubissues

I've just made a part for the IN-12 Russian nixie tube for a project(8 bit 
relay + valve computer) I'm working on because using headers with named pins 
were getting unwieldy and not very elegant.

Since I spent a bit of time on making it I felt it would be nice to share it 
with everyone. As far as I can gather from several datasheets of the same part 
there is slight deviation to the dimensions of the glass envelope which means 
the dimensions of the part in Fritzing is only accurate to within 1mm. Which is 
likely within tolerances for glass working anyway so I don't believe this to be 
an issue. The PCB pin holes, however, are consistent and should be correct but 
it's always wise to get a pair of calipers on it before you make pcbs with 
tubes.

I'm also posting on here to ask if there is any interest in a finished set of 
IN series nixies? If there is some desire for these tubes please suggest which 
ones are most requested. I'll already be doing the IN-18 variety which is 
commonly used in 'Nixie Clocks'.

Screenshot of part:
https://dl.dropboxusercontent.com/u/45524288/IN-12_NIXIE_12_screenshot.png

Download:
https://dl.dropboxusercontent.com/u/45524288/Programming/IN-12%20Nixie%20tube.fz
pz

Thanks for any suggestions. :)

Original issue reported on code.google.com by Sparks...@gmail.com on 5 Jan 2015 at 10:47

buixuanan / fritzing

Nixie tubes #3020