search

buixuanan / fritzing

Automatically exported from code.google.com/p/fritzing
0 stars 0 forks source link

Jumper items are not selectable #889

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago 
Once a jumper wire was created during the autorouting process, it seems to be 
not selectable and therefore not movable or deletable.

Original issue reported on code.google.com by andre.knoerig@gmail.com on 27 Oct 2009 at 11:53

GoogleCodeExporter commented 9 years ago 
Can you give a more specific example?  Tried this with the old stepper motor 
example 
(not the recently updated one), which has lots of jumper wires.  After the 
autoroute, 
there was a long delay before I could select anything (which may be a separate 
bug), 
but then I had no problem selecting/deleting jumper wires.  Or do you mean 
jumper 
items?

By the way, are there supposed to be jumper items in the updated stepper motor 
example?  
Because if so, they're not showing up when I load that example.

Original comment by irasc...@gmail.com on 28 Oct 2009 at 5:30

GoogleCodeExporter commented 9 years ago 
Playing a bit more with it, a jumper wire seems to be only selectable at the 
copper 
circles. The blue line itself is not clickable. It would be nice if that was 
possible, 
in order to delete it.

Yes, the stepper motor is the only example in which I made use of the new 
jumper 
wires. And you're right, the lines do not show up immediately. But if you move 
one of 
their copper circles, the blue line gets drawn..

Which shows another bug: If you move the endpoint of a jumper wire, the traces 
connected to it do not move with it.

And finally: the ratsnest doesn't get dimmed properly when a jumper wire got 
created.

Should I put these things into separate issues?

Original comment by andre.knoerig@gmail.com on 28 Oct 2009 at 9:15

GoogleCodeExporter commented 9 years ago 
Do you mean "jumper wire" or "jumper item"?  I still can't tell which one you 
are 
talking about.  "Jumper Wire" is a wire, and it's the thing that will 
eventually be 
replaced by a fat ratsnest wire.  Jumper Item is the new thing with actual 
pads--it is 
a part and not a wire.

Original comment by irasc...@gmail.com on 28 Oct 2009 at 10:50

GoogleCodeExporter commented 9 years ago 
Sorry, I mean the new guy, jumper item.

Original comment by andre.knoerig@gmail.com on 28 Oct 2009 at 11:27

GoogleCodeExporter commented 9 years ago 
clarifying summary

Original comment by irasc...@gmail.com on 28 Oct 2009 at 11:31

GoogleCodeExporter commented 9 years ago 
r3669: jumper item now can be dragged by clicking on the blue line (connector 
"halo" 
dragging still works), and if you move a jumper, or one if its connectors, 
connected 
traces move along with it

Original comment by irasc...@gmail.com on 28 Oct 2009 at 10:36

GoogleCodeExporter commented 9 years ago 
looking into the "lines not showing" bug next

Original comment by irasc...@gmail.com on 28 Oct 2009 at 10:37

GoogleCodeExporter commented 9 years ago 
r3670: virtual wire subpart is now being draw when part is loaded from an fz

closing this bug and opening another one about the ratsnest

Original comment by irasc...@gmail.com on 29 Oct 2009 at 2:32