search

bwack / C64-Saver-bwack

Other
98 stars 14 forks source link

330K Resistor #38

Open brendan1495 opened 7 months ago

brendan1495 commented 7 months ago

Hi, not really an issue but I am in the UK and really strugging to get hold of a 04W 330K resistor, I can get hold of 300K 0.4W will this be Ok. Sorry for the noob question.

Brendan

jhiggason commented 7 months ago

Can you find higher wattage? I'd have to look at the schemetic again to see what the 330k are doing...but the easiest would be looking for higher wattage resistors.

I'm sure the other guys here can give you better information ❤️

brendan1495 commented 7 months ago

Hi jhiggason, thanks for the quick reply, I could get higher but how high can I go?

jdecupere commented 7 months ago

Hi Brendan, That resistor is not critical. It just provides some hysteresis to the switching point to avoid an unstable state when just triggering the safe mode. Whether that is 330k or 300k Ohm does not matter much. Just take something close that has the same size physically - wattage is also not important...if you think about it - even if you had the full VCC over it, it will still just be in the order of 0.1mW range. Joost

brendan1495 commented 7 months ago

Hi Brendan, That resistor is not critical. It just provides some hysteresis to the switching point to avoid an unstable state when just triggering the safe mode. Whether that is 330k or 300k Ohm does not matter much. Just take something close that has the same size physically - wattage is also not important...if you think about it - even if you had the full VCC over it, it will still just be in the order of 0.1mW range. Joost

Thanks a lot, managed to get some 300k in 0.4W. 0.4W resisters seem to be really hard to get in the UK in small numbers. Obviously I could use digikey or mouser but postage is very expensive unless buying lots. Thanks for the reply, I can get to building them now.

Brendan