I don't know if I am in the right place for this, but there was a new issue that came.up. The pi zero puts out a DVI signal at 60hz and just as the power is turned on, the rainbow splash screen flickers for a second then goes black. Between Paula, Agnus and Denise, I have tried resetting them best I could and nothing changes. I tried holding down the toggle button on that two pin connection, and no menu came.up at all. I was reading that perhaps the /CDAC and /CSYNC lines needed to be tied in? Wasn't sure if that would solve the issue or not.
I don't know if I am in the right place for this, but there was a new issue that came.up. The pi zero puts out a DVI signal at 60hz and just as the power is turned on, the rainbow splash screen flickers for a second then goes black. Between Paula, Agnus and Denise, I have tried resetting them best I could and nothing changes. I tried holding down the toggle button on that two pin connection, and no menu came.up at all. I was reading that perhaps the /CDAC and /CSYNC lines needed to be tied in? Wasn't sure if that would solve the issue or not.