caiwang / board2ihost

0 stars 0 forks source link

hostapd on pi vs. on rock #46

Open caiwang opened 9 years ago

caiwang commented 9 years ago

Issue by caiwang Tuesday Mar 03, 2015 at 09:55 GMT Originally opened as https://github.com/caiwang/ihostsrc/issues/46


on pi

root@ihost:~# hostapd -d /etc/hostapd/hostapd.conf random: Trying to read entropy from /dev/random Configuration file: /etc/hostapd/hostapd.conf nl80211: interface wlan0 in phy phy0 rfkill: initial event: idx=0 type=1 op=0 soft=0 hard=0 nl80211: Using driver-based off-channel TX nl80211: Add own interface ifindex 3 nl80211: Set mode ifindex 3 iftype 3 (AP) nl80211: Create interface iftype 6 (MONITOR) nl80211: New interface mon.wlan0 created: ifindex=7 nl80211: Add own interface ifindex 7 BSS count 1, BSSID mask 00:00:00:00:00:00 (0 bits) nl80211: Regulatory information - country=00 nl80211: 2402-2472 @ 40 MHz nl80211: 2457-2482 @ 40 MHz nl80211: 2474-2494 @ 20 MHz nl80211: 5170-5250 @ 160 MHz nl80211: 5250-5330 @ 160 MHz nl80211: 5490-5730 @ 160 MHz nl80211: 5735-5835 @ 80 MHz nl80211: 57240-63720 @ 2160 MHz nl80211: Added 802.11b mode based on 802.11g information Completing interface initialization Mode: IEEE 802.11g Channel: 11 Frequency: 2462 MHz nl80211: Set freq 2462 (ht_enabled=0 sec_channel_offset=0) Failed to update rate sets in kernel module RATE[0] rate=10 flags=0x1 RATE[1] rate=20 flags=0x1 RATE[2] rate=55 flags=0x1 RATE[3] rate=110 flags=0x1 RATE[4] rate=60 flags=0x0 RATE[5] rate=90 flags=0x0 RATE[6] rate=120 flags=0x0 RATE[7] rate=180 flags=0x0 RATE[8] rate=240 flags=0x0 RATE[9] rate=360 flags=0x0 RATE[10] rate=480 flags=0x0 RATE[11] rate=540 flags=0x0 Flushing old station entries Deauthenticate all stations wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=0 set_tx=0 seq_len=0 key_len=0 wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=1 set_tx=0 seq_len=0 key_len=0 wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=2 set_tx=0 seq_len=0 key_len=0 wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=3 set_tx=0 seq_len=0 key_len=0 Using interface wlan0 with hwaddr 7c:dd:90:21:7f:a1 and ssid 'Matrix' VLAN: vlan_set_name_type(name_type=2) nl80211: Set beacon (beacon_set=0) wpa_driver_nl80211_set_operstate: operstate 0->1 (UP) netlink: Operstate: linkmode=-1, operstate=6 wlan0: Setup of interface done. random: Got 20/20 bytes from /dev/random RTM_NEWLINK: operstate=1 ifi_flags=0x1102 () nl80211: Ignore interface down event since interface wlan0 is up RTM_NEWLINK: operstate=1 ifi_flags=0x1002 () nl80211: Ignore interface down event since interface mon.wlan0 is up RTM_NEWLINK: operstate=1 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP]) RTM_NEWLINK, IFLA_IFNAME: Interface 'mon.wlan0' added Unknown event 5 RTM_NEWLINK: operstate=1 ifi_flags=0x1103 ([UP]) RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added nl80211: if_removed already cleared - ignore event RTM_NEWLINK: operstate=1 ifi_flags=0x11143 ([UP][RUNNING][LOWER_UP]) RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added nl80211: if_removed already cleared - ignore event VLAN: vlan_newlink(wlan0) mgmt::deauth cb

Signal 2 received - terminating Flushing old station entries Deauthenticate all stations nl80211: Remove interface ifindex=7 netlink: Operstate: linkmode=0, operstate=6 nl80211: Set mode ifindex 3 iftype 2 (STATION)

caiwang commented 9 years ago

Comment by caiwang Tuesday Mar 03, 2015 at 10:11 GMT


on rock

root@radxa:~# hostapd -dd -K /etc/hostapd/hostapd.conf random: Trying to read entropy from /dev/random Configuration file: /etc/hostapd/hostapd.conf rfkill: initial event: idx=0 type=1 op=0 soft=0 hard=0 rfkill: initial event: idx=1 type=2 op=0 soft=0 hard=0 nl80211: Supported cipher 00-0f-ac:1 nl80211: Supported cipher 00-0f-ac:5 nl80211: Supported cipher 00-0f-ac:2 nl80211: Supported cipher 00-0f-ac:4 nl80211: Using driver-based off-channel TX nl80211: Disable use_monitor with device_ap_sme since no monitor mode support detected nl80211: interface wlan1 in phy phy0 nl80211: Set mode ifindex 4 iftype 3 (AP) nl80211: Failed to set interface 4 to mode 3: -95 (Operation not supported) nl80211: Try mode change after setting interface down nl80211: Set mode ifindex 4 iftype 3 (AP) nl80211: Failed to set interface 4 to mode 3: -95 (Operation not supported) nl80211: Interface mode change to 3 from 0 failed nl80211: Could not configure driver mode nl80211: Remove monitor interface: refcount=0 netlink: Operstate: ifindex=4 linkmode=0 (kernel-control), operstate=6 (IF_OPER_UP) nl80211: Set mode ifindex 4 iftype 2 (STATION) nl80211 driver initialization failed. hostapd_interface_deinit_free(0x1a046f0) hostapd_interface_deinit_free: num_bss=1 conf->num_bss=1 hostapd_interface_deinit(0x1a046f0) hostapd_bss_deinit: deinit bss wlan1 hostapd_cleanup(hapd=0x1a05308 (wlan1)) hostapd_free_hapd_data: Interface wlan1 wasn't started hostapd_interface_deinit_free: driver=(nil) drv_priv=(nil) -> hapd_deinit hostapd_interface_free(0x1a046f0) hostapd_interface_free: free hapd 0x1a05308 hostapd_cleanup_iface(0x1a046f0) hostapd_cleanup_iface_partial(0x1a046f0) hostapd_cleanup_iface: free iface=0x1a046f0