Running SoapyRemote for cariboulite and CubicSDR as the client.
I select the S1G device and start the device with supported frequency... 900 MHz let's say. If I scroll through an unsupported frequency I get a message on soapyremote end that the frequency is unsupported. That's fine.
But, if I go to a frequency that's supported I get:
09-28 20:51:09.482 7136 7156 E CARIBOULITE Radio cariboulite_radio_set_frequency@cariboulite_radio.c:680 Unsupported frequency for the ISM S1G channel - 349700000.00 Hz, deactivating channel
caribou_smi_read -> Timeout09-28 20:52:49.282 7136 7156 E CARIBOULITE Radio cariboulite_radio_set_frequency@cariboulite_radio.c:680 Unsupported frequency for the ISM S1G channel - 347600000.00 Hz, deactivating channel
caribou_smi_read -> Timeout
caribou_smi_read -> Timeout
I start/stop again on a supported frequency - works again.
What I can say that on the SoapyRemote end, I don't see a switch to the new frequency only the timeout
Running SoapyRemote for cariboulite and CubicSDR as the client. I select the S1G device and start the device with supported frequency... 900 MHz let's say. If I scroll through an unsupported frequency I get a message on soapyremote end that the frequency is unsupported. That's fine. But, if I go to a frequency that's supported I get:
I start/stop again on a supported frequency - works again. What I can say that on the SoapyRemote end, I don't see a switch to the new frequency only the timeout