cdsteinkuehler / MachineKit

Stable versions occasionally updated. For development, see: https://github.com/cdsteinkuehler/linuxcnc
Other
8 stars 9 forks source link

doc request: Note supported capes on MachineKit page #6

Closed brandonheller closed 11 years ago

brandonheller commented 11 years ago

I'm not sure what's been tested here. If you want me to directly make changes to the page for minor stuff like this instead, let me know.

cdsteinkuehler commented 11 years ago

Feel free to directly make changes like this. That's why I added you as a blog author, rather than just copying your post onto the blog. At the moment, the only cape known to work is the BeBoPr. The K9 should work but I don't have one to test with (yet) and they're not generally available. I'm hoping someone works on getting a Replicape and maybe I'll get time to make the CapeR (RAMPS to Cape interface) board I have planned.

brandonheller commented 11 years ago

I would do that, but I don't actually have permissions to modify pages or posts; I can only add new ones. Can you check my permissions if you'd prefer direct edits (which I'd also prefer, of course - a little trust saves a lot of wasted time).

brandonheller commented 11 years ago

Fixed.