Closed enorfelt closed 3 years ago
I have this exact same problem, did you manage to find a good workaround? The PCB not moving inside the tube is kind of key to the working of this device..
I'm sorry, you can use a scotch tape on top of battery.Il 14 Apr 2021 20:05, ljruiten @.***> ha scritto: I have this exact same problem, did you manage to find a good workaround? The PCB not moving inside the tube is kind of key to the working of this device..
—You are receiving this because you are subscribed to this thread.Reply to this email directly, view it on GitHub, or unsubscribe.
@enorfelt actually after further investigation this is not an issue... You have to realize that in the perfect situation the ispindel should have three contact points with the casing: either side of the PCB, and the battery... Therefore the PCB is not centered in the casing, it is lowered, get it? I just added the battery holder and the battery and could not even fit the PCB in the case, had to sand down the sides of the PCB which now has a perfect fit with the case.
@enorfelt actually after further investigation this is not an issue... You have to realize that in the perfect situation the ispindel should have three contact points with the casing: either side of the PCB, and the battery... Therefore the PCB is not centered in the casing, it is lowered, get it? I just added the battery holder and the battery and could not even fit the PCB in the case, had to sand down the sides of the PCB which now has a perfect fit with the case.
That makes perfect sense! Thank you 😊
Just received my boards from pcbway. When I ordered them I saw that they where 31mm wide. Is that correct? They feel kind of loose in an XL petling with 33mm inner dimension.
Thx!