sticky safety switch

[GoogleCodeExporter]

Hi, will be possible define a safety switch configuration for Throttle in 
"stick" manner?  i use the GyroGearloose config. in all my models but is a 
hassle have to copy all channel 14 config. and the custom switches all time.

the sticky version of throttle safety switch is:  once the physical switch is 
activated the throttle output is zeroed, and if the gimbal is no in the lower 
position when the switch is put in back position the output still zero until 
the gimbal goes down then the output is again governed by the gimbal.

regards.

Original issue reported on code.google.com by impe...@gmail.com on 26 Jul 2012 at 4:06

[GoogleCodeExporter]

Hi, somebody can help me?  it may be a good addition?

Original comment by impe...@gmail.com on 9 Oct 2012 at 4:50

[GoogleCodeExporter]

It will involve quite a lot of code to implement.
You shouldn't need to copy the "sticky throttle cut" mix and switches, just use 
the template for it either in er9x, or using eepe.

Original comment by michael....@mypostoffice.co.uk on 14 Dec 2013 at 3:25

[GoogleCodeExporter]

Hi, thanks for your response, i know i can do it, but it takes a lot of memory 
and duplicated memory in each model 

Original comment by impe...@gmail.com on 16 Dec 2013 at 1:58

[GoogleCodeExporter]

I've found a way to do this, it should be in r809.
There will be an extra 'type' in the safety switch menu in addition to 'S', 'A' 
and 'V' that will be a 'sticky' safety switch, specifically using the throttle 
stick.

Original comment by michael....@mypostoffice.co.uk on 18 Dec 2013 at 1:02

[GoogleCodeExporter]

Thanks i will be waiting for it.

Original comment by impe...@gmail.com on 18 Dec 2013 at 1:21