chinlin0924 / er9x

Automatically exported from code.google.com/p/er9x
0 stars 0 forks source link

Can't change "owner name" in setup if PotScroll is turned off #716

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago
What steps will reproduce the problem?

1. Go to setup page 1  - "Radio Setup"
2. Set PotScroll to "OFF"
3. Select "Owner name" field
4. Try to change owner name by pressing "Menu" key

What is the expected output? What do you see instead?

Switching to edit mode after pressing "Menu" key is expected, but nothing 
happens.

What version of the product are you using? On what operating system?
er9x-r780

Original issue reported on code.google.com by epi4s...@yandex.ru on 16 Dec 2012 at 7:27

GoogleCodeExporter commented 9 years ago
I also have r780 and see the same behavior.  Unable to edit Owner Name field 
unless I enable PotScroll.  Other text editing (e.g. model names) works 
correctly.

Original comment by ch...@acrocad.net on 28 Dec 2012 at 3:07

GoogleCodeExporter commented 9 years ago
I have same issue with ver 780 but potscroll does not have any affect ver 778 
works but missing the  editing in the mixer which I like. Tom

Original comment by sarell.t...@gmail.com on 29 Dec 2012 at 11:30

GoogleCodeExporter commented 9 years ago
er9x ver780 the editing of the model name the left and right change the name 
letter also until exit is pushed owner name cannot be edited when entering a 
template need to press exit to move up or down. I think these change are due 
testing of REM or rotarty sw

Original comment by sarell.t...@gmail.com on 30 Dec 2012 at 1:39

GoogleCodeExporter commented 9 years ago
I believe this was fixed in r781.

Original comment by michael....@mypostoffice.co.uk on 14 Dec 2013 at 4:14

GoogleCodeExporter commented 9 years ago

Original comment by michael....@mypostoffice.co.uk on 18 Dec 2013 at 1:27