search

chinlin0924 / er9x

Automatically exported from code.google.com/p/er9x
0 stars 0 forks source link

Parameters are not savings in Radio Setup menu #754

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1. Changing some parameters in Radio Setup menu
2. Waiting some times for savings
3. Power Off and Power On the TX

What is the expected output? What do you see instead?
Changings and savings of parameters. I see some parameters returns to its 
original state.

What version of the product are you using? On what operating system?
Turnigy 9X
V1.2432-Mike
10.01.2015
20:07:21
er9x-r816

Please provide any additional information below.

The following parameters is not save in the Radio Setup menu.
After power off and Power on the values returns to its original states.
All other parameters savings normally.

1)Flash on beep
2)Beep countdown
3)Splash screen
4)Splash name
5)PotScroll
6)StickScroll
7)CrossTrim
8)Throttle reverse
9)BandGap

Original issue reported on code.google.com by nrbuda...@gmail.com on 20 Feb 2015 at 7:13

GoogleCodeExporter commented 9 years ago 
I can't make this happen. I just downloaded and flashed the FrSky version (as 
my Tx is modified for that) and those values do get saved.
In the top left corner of the display is a flashing line if the EEPROM has not 
yet been written. Make sure you wait until this disappears before switching off.

Original comment by michael....@mypostoffice.co.uk on 20 Feb 2015 at 10:09

GoogleCodeExporter commented 9 years ago 
I always wait for the indicator stops flashing before turn off the TX. I have 
tried several times to reflash the transmitter (I use usbasp for flashing). But 
it is always the same. I tried firmware Open9x - no problem, but I like er9x 
more.

Original comment by nrbuda...@gmail.com on 21 Feb 2015 at 5:22

GoogleCodeExporter commented 9 years ago 
The only way to change these settings - through eePe (Read Memory From TX -> 
Change parameters -> Write Memory To TX)

Original comment by nrbuda...@gmail.com on 21 Feb 2015 at 5:26

GoogleCodeExporter commented 9 years ago 
On this forum thread: http://openrcforums.com/forum/viewtopic.php?f=5&t=4598 
are test versions for new features. Please try flashing the one from 
05-Feb-2015 18:35 and see if the problem is fixed.

Original comment by michael....@mypostoffice.co.uk on 21 Feb 2015 at 9:23

GoogleCodeExporter commented 9 years ago 
With this version problem is fixed! But is it stable version?

Original comment by nrbuda...@gmail.com on 22 Feb 2015 at 5:30

GoogleCodeExporter commented 9 years ago 
It should be stable. A new manual is being produced so these test versions have 
been tested while making sure the manula matches them.

Original comment by michael....@mypostoffice.co.uk on 22 Feb 2015 at 5:41

GoogleCodeExporter commented 9 years ago 
Ok. Thanks!

Original comment by nrbuda...@gmail.com on 22 Feb 2015 at 5:46