Tracer is very close to mounting screw.

chris-jh / mt32-pi-midi-hat

A Raspberry Pi Midi Hat for the project mt32-pi by Dale Whinham (https://github.com/dwhinham/mt32-pi)

GNU General Public License v3.0

79 stars 4 forks source link

Tracer is very close to mounting screw. #3

Closed skadarnold closed 3 years ago

skadarnold commented 3 years ago

Minor issue where the tracer next to this GPIO pin can be exposed when tightening mounting screws to raspberry pi case. Recommended using a washer or nylon screws when using version 1.7 of this hat. Causes the raspberry pi to short when turning on. Did not cause any damage from what I can tell as removing the screw allowed everything to work as it should. It is also worth mentioning that I tightened as normal, and did not necessarily over tighten this screw.

signal-2021-03-08-082729

chris-jh commented 3 years ago

I will move it, when i get around, good call. Although i used nylon screws, so never noticed.

chris-jh commented 3 years ago

fixed