search

chutinhha / open-hardware-monitor

Automatically exported from code.google.com/p/open-hardware-monitor
0 stars 0 forks source link

Missing Temp. sensor for Gigabyte GA-970A-UD3 since 0.6.0 #625

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago 
There were 3 temperatures sensors for Gigabyte GA-970A-UD3 (ITE IT8720F) at the 
old version of Open Hardware Monitor 0.4.0.

Now with the new version 0.6.0 one sensor is missing (see attached picture).

Original issue reported on code.google.com by brainbu...@googlemail.com on 11 Oct 2014 at 11:08

Attachments:

GoogleCodeExporter commented 8 years ago 
Version 0.6.0 uses a mainboard specific configuration for the Gigabyte 
GA-970A-UD3 which (should) provide correct voltage scaling and labeling of 
sensors. Also any sensor channels not displayed in the BIOS are hidden because 
it is unknown if and to what they are connected.

Version 0.4.0 presented just the raw data from the monitoring chip. I could add 
the sensor back in if either Gigabyte EasyTune6 (do not run it at the same time 
as OHM) or the BIOS shows the third temperature sensor as well on your system, 
or you have any other hint on the meaning of the third "temperature". To know 
for sure one would need the schematics of the board.

Original comment by moel.mich on 29 Dec 2014 at 12:24