cjbaar / prusa-mmu-12x

Modified Prusa MMU2/3 model for up to 12 filaments
151 stars 18 forks source link

mmu12x-inlet is not a manifold #9

Closed KaruroChori closed 3 years ago

KaruroChori commented 3 years ago

Trying to slice mmu12x-inlet in cura will result in visible holes on top of the geometry. SuperSlicer with a similar profile is able to repair the mesh before slicing.

cjbaar commented 3 years ago

PrusaSlic3r tells me "Auro-repaired 10 errors." The top gets a bit odd with the slight angle on the threads, but I have printed the part several times without issue.

KaruroChori commented 3 years ago

Yes, same as with SuperSlicer; as they are both forks of Slic3r it does make sense I guess. I was able to print it just as you said, which is why I had closed this issue.

Btw, thank you for sharing. It is going to be a lot of fun!