Closed schuh8 closed 1 year ago
some boards have their runout sensor enable pin pulled HIGH
or LOW
. if the filament runout sensor is not plugged in this can trigger the advanced pause during print. either switch it to low or disable the feature altogether.
I mistakenly left it enabled at HIGH during compilation for this board.
This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.
Aquila w/ 4.2.7 and Creality-427-ProUI-UBL.bin . As mentioned on the reddit forum and documenting here. When starting a print and just after the start script executes I get a "advanced pause, purge or continue". The only way around the problem is to go into filament settings and deselect "enable runout". I can then restart the print and it will print normally. Sometimes when the printer is turned off the box defaults to checked and the problem reappears. Sometimes on restarting it remains unchecked.