Tried to flash my Eachine E010S board because the FW update was pushed from the Cleanflight (unable to configure board just cli with a message need FW flash).
No reboot sequence, flash on connect , full chip erase and manual baud rate have I tried to change but without any success.
What do I have to do to be able to flash the FW?
you need the reboot sequence to get the board into bootloader mode unless you manually do this via a switch/jumper first. please use rcgroups for user support, not the github issue tracker.
Tried to flash my Eachine E010S board because the FW update was pushed from the Cleanflight (unable to configure board just cli with a message need FW flash). No reboot sequence, flash on connect , full chip erase and manual baud rate have I tried to change but without any success. What do I have to do to be able to flash the FW?
BR
J.