Micron housing update, the bridge no longer turns a corner in mid air resulting in bad prints
V2.4 housing had a similar issue where the bridge turned a corner, this has now been fixed as well
updated the carriers for V2/VT to let the pin snap in and stay in
you can see the new one the opening is just slightly smaller (5mm) compared to where the pin seats (5.2mm) so it helps it stay in
also updated the Micron/SF carrier as it had a gap here that wasnt needed
made housings more printable for Micron and V2
Micron housing update, the bridge no longer turns a corner in mid air resulting in bad prints
V2.4 housing had a similar issue where the bridge turned a corner, this has now been fixed as well
updated the carriers for V2/VT to let the pin snap in and stay in you can see the new one the opening is just slightly smaller (5mm) compared to where the pin seats (5.2mm) so it helps it stay in
also updated the Micron/SF carrier as it had a gap here that wasnt needed