search

comakingspace / do-something

CoMakingSpace tasks and small projects
21 stars 2 forks source link

Printer P3 should be checked #155

Closed NitramLegov closed 4 years ago

NitramLegov commented 4 years ago

Today, P3 had the issue that the belt of the x-axis skidded down.

I put the belt back on and tightened it. Afterwards, I ran a calibration cycle of the xyz axis. However, I did not yet set the first layer height!

While the calibration did run through successfully, the printer sounded a little bit odd (to me). This should be double checked either by the area patrons (@Narquadah , @reogaro ) or by the inventory manager @Pakue95

Narquadah commented 4 years ago

P3 also had a clog, @Pakue95 @reogaro and I fixed it yesterday; however, the printer is not calibrated at all.

LukasFreeze commented 4 years ago

@Pakue95 (I think?) calibrated it and we did a auccessful test print yesterday.