The bed leveling on P5 fails at the second probe point (front center): after "touching down" for the first time, the head travels up again and leveling is stopped with the error message "probe triggered too high"
The G-code ran fine on another printer, have not tried anything else yet. Do we know this problem? What could be done about it?
Perhaps also related to this: on Friday, a job on this printer had to be aborted because the nozzle lowered itself into the print around Z=20 mm
The bed leveling on P5 fails at the second probe point (front center): after "touching down" for the first time, the head travels up again and leveling is stopped with the error message "probe triggered too high"
The G-code ran fine on another printer, have not tried anything else yet. Do we know this problem? What could be done about it?
Perhaps also related to this: on Friday, a job on this printer had to be aborted because the nozzle lowered itself into the print around Z=20 mm