Closed kenomaerz closed 3 years ago
How exactly is the focusing supposed to work for this machine? Is it not possible to adjust the calibration help?
On Thu, Jun 25, 2020 at 1:35 PM Keno März notifications@github.com wrote:
Yesterday, @Pakue95 https://github.com/Pakue95, @NitramLegov https://github.com/NitramLegov and I found, that the laser cutter focusing help is not calibrated correctly. To achieve best focus, you need to aim the calibration help ~5mm to the right of the actual laser beam, which is not quite optimal.
We probably need to contact the manufacturers for a fix.
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/comakingspace/do-something/issues/203, or unsubscribe https://github.com/notifications/unsubscribe-auth/AEWXG266IGGBSOD7M3PDKNTRYMZBFANCNFSM4OII4FFA .
@Johannes09 and me took a look at the calibration help (laser pointer) and adjusted it a bit. We'll need to check whether it was enough or not.
We'll need to check whether it was enough or not.
Did that work?
I have been using Patrick's calibration helper and have been getting good results. I'll close this for now.
Yesterday, @Pakue95, @NitramLegov and I found, that the laser cutter focusing help is not calibrated correctly. To achieve best focus, you need to aim the calibration help ~5mm to the right of the actual laser beam, which is not quite optimal.
We probably need to contact the manufacturers for a fix.