Bigger nozzle sizes for the 3d printers

[Titan-OX]

I bought some 0.8mm high flow nozzles and installed one in P2. Results turned out great as I could easily print a fullsize benchy in under 30 minutes.

I believe we should have mixed nozzle sizes as we have a lot of printers and sometimes you need a fine 0.4mm for details but also something big and fast as printing times have made some prints previously impossible. Also there was the suggestion to downgrade the Multimaterial printer as it was only used like twice in 5 years of makerspace history.

What needs to be done:

• [ ] decided what printers should get what nozzles
• [x] change the introduction to inform about the importance of slicing for the right nozzle size
• [x] document it in the printer page

[Titan-OX]

closing the issue because we can decide later on if we need even more nozzle sizes in different printers and don't need an issue for this