Hey again, after i sort everything out as far as the code. i did install the hex flawlessly. I follow each and every step as far as the mesh bed leveling and also changed the coding in the slicer. Note i did the procedure 3 time with the exact same results. Using the mesh procedure i leveled the bed flawlessly, i have tried to help the software by physically level the bed correct, and started my print. For starters while it is printing the skirt in a circular motion it does something which look like binding and the whole printer tremble after finishing with the skirt the nozzle goes inside the skirt as usual and start slide on the glass with force while making some noise. note* few mm further it did print the skirt few second before. i did the same procedure 3 times with the exact same outcome.
I would like to know if it is possible to use the stock sensor in any way, cause i was pretty satisfied with it not the most convenient way but after the grid i was giving with M851 the z offset in starting g code and worked pretty good. i would like to have the same ability plus the advantages off this firmware.. Thanks again.
ps i will flash the stock firmware and try to replicate that binding to take off the table the possibility of being something on the hardware side.
UPDATE!!! Binding was a slicing issue nothing to do with this firware!!
UPDATE@2 tried for many hours to make bilinear leveling to work even stated to mess with lcd.cpp file but with no hope my skills just don't cut it.
Hey again, after i sort everything out as far as the code. i did install the hex flawlessly. I follow each and every step as far as the mesh bed leveling and also changed the coding in the slicer. Note i did the procedure 3 time with the exact same results. Using the mesh procedure i leveled the bed flawlessly, i have tried to help the software by physically level the bed correct, and started my print. For starters while it is printing the skirt in a circular motion it does something which look like binding and the whole printer tremble after finishing with the skirt the nozzle goes inside the skirt as usual and start slide on the glass with force while making some noise. note* few mm further it did print the skirt few second before. i did the same procedure 3 times with the exact same outcome.
I would like to know if it is possible to use the stock sensor in any way, cause i was pretty satisfied with it not the most convenient way but after the grid i was giving with M851 the z offset in starting g code and worked pretty good. i would like to have the same ability plus the advantages off this firmware.. Thanks again.
ps i will flash the stock firmware and try to replicate that binding to take off the table the possibility of being something on the hardware side.
UPDATE!!! Binding was a slicing issue nothing to do with this firware!!
UPDATE@2 tried for many hours to make bilinear leveling to work even stated to mess with lcd.cpp file but with no hope my skills just don't cut it.
Downloads.zip
upload info.zip