Open coadotvn opened 4 years ago
That's awesome. What kind of led strip did you use if you don't mind my asking?
That's awesome. What kind of led strip did you use if you don't mind my asking?
any 5v led strip will works, just solder its pin to power led holes on the pcb, it will works
You can solder the ws2812's data pin on PIN D0 and define config with QMK firmware. I did it and worked fine
You can solder the ws2812's data pin on PIN D0 and define config with QMK firmware. I did it and worked fine
Can you pls share where is pin D0?
you can find it from datasheet. This is 14th pin (RXD -PD0)
I just solder it into the power led holes, then control it by a RF remote. If there is any way to solder a led strip, to be controlled by the pcb, it will be best.