search

cpainchaud / RFLink32

RFLink for ESP, with MQTT client
Other
119 stars 44 forks source link

Can't get data from Alecto ws1200 weather station #57

Open Marc1200 opened 1 year ago

Marc1200 commented 1 year ago

Hello,

The rflink is fully working now, i can receive kaku remote control signals. I cannot receive the signal from my Alecto ws1200 weatherstation. Alecto ws1200 is plugin 31, is this plugin disabled bij default?

elodur commented 1 year ago

Same question: I downloaded the precompiled firmware for ESP32 Dev Board, works so far, about 250 counts in 30 minutes but only 1 decoded. As I have an original RFLink gateway as well, I know there are signals from alectov, aureol_v3 and lacrosse to receive, which should also be recognized by RFLink32. So I have to activate those plugins? Looking at the sourcecode in GitHub they should be active, or did I mix it up? An old remote for powerplugs ist decoded as kaku, but since I have Zigbee I don't need it any more.

yndtrud commented 1 year ago

Some problem with Oregon Weather Station, signals are very rarely decoded.

cpainchaud commented 1 year ago

@elodur if you know for sure that all these devices are running around your house then if I were you I would double check antenna placement, circuitry for any noise and your receiver ofc, RXB6 for example area kind of lottery in term of quality. You can also to get closer to a source to confirm it's not a reception quality problem.

elodur commented 1 year ago

The devices belong to my neighbours, I don't know where they are located. My question aimed at the activation of plugins, but as they seem to be active by default it must be a problem of reception. I will try another RXB6 and RXB8 I've got. Sadly the Aurel transceiver from the original RFLink seems to be out of production, it works very good.