1. Stratux version: 1.6r1-eu021
2. Stratux config: only SoftRF connected, powered via PowerBank / Config file below
3. EFB app and version: N/A
4. Description of issue:
Connected my SoftRF and it is not connecting (see screenshots)
Whenn SSH'ing into STRATUX I can see the device as cp210x converter attached to ttyUSB0
When I do a "stty -F /dev/flarm" (again and again) I get conflicting baudrates shown: 9600, 38400 & 115200 (IMHO this should be 38400)?
When I set this to 38400 it will fluctuate again to 115200 (or 9600 or 38400) ...
When I do a head -4 on /dev/flarm (probably related to the changing baud rates?)
If you have an issue with Stratux EU, please open it there, not here. This feature has nothing to do with the pseudo-integration of SoftRF in Stratux-US.
Your setup is wrong. Stratux-EU uses the NMEA output from SoftRF, not dump1090 output.
Set NMEA output to serial, disable GDL90 and dump1090 output.
1. Stratux version: 1.6r1-eu021 2. Stratux config: only SoftRF connected, powered via PowerBank / Config file below 3. EFB app and version: N/A 4. Description of issue: Connected my SoftRF and it is not connecting (see screenshots)
Whenn SSH'ing into STRATUX I can see the device as cp210x converter attached to ttyUSB0
When I do a "stty -F /dev/flarm" (again and again) I get conflicting baudrates shown: 9600, 38400 & 115200 (IMHO this should be 38400)? When I set this to 38400 it will fluctuate again to 115200 (or 9600 or 38400) ...
When I do a head -4 on /dev/flarm (probably related to the changing baud rates?)
I have a second Prime, but it shows the same behavior, so I guess I am doing a dumb mistake :)
THANKS for your help where to look!!