search

d3ru / eggbotcode

Automatically exported from code.google.com/p/eggbotcode
0 stars 0 forks source link

Parameter changes not picked up by Manual Control #7

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago 
Originally Reported by westfw, May 25 (4 days ago)

If you make changes and "apply" them in the Configuration menu (servo
up/down position, step speed, etc), those changes will be sent to the
eggbot board the next time "Start" is clicked to begin the plot, but the
changes are NOT picked up when you move to the "Manual Control" window in
an attempt to try them out...

Original issue reported on code.google.com by windell@oskay.net on 30 May 2010 at 11:43

GoogleCodeExporter commented 9 years ago 
Can you please re-verify this issue, and say which platform(s) it is on?

- The extension does, in principle, save data in a configuration file.

- I have verified that the configuration file is saved on Mac and Linux, at 
least for the parameter that I tested,  
"delay after lowering pen." I assume that the issue as you have seen it applies 
to all items in the pane.

- If this cannot be reproduced the issue should be closed.

Original comment by windell@oskay.net on 6 Jun 2010 at 1:47

GoogleCodeExporter commented 9 years ago 
I have tried and have been unable to reproduce this issue on Mac and Linux.

Original comment by windell@oskay.net on 7 Jun 2010 at 12:13

GoogleCodeExporter commented 9 years ago 
We've replaced the development trunk with a new version on 6/11/10.  As this 
issue was specific to the old version, I'm closing it at this time.

Original comment by windell@oskay.net on 11 Jun 2010 at 4:43