Closed bazarovdev closed 1 year ago
Testing with scope and minicom
I saw that the /dev/pts/#
actually "works" but:
minicom -D /dev/pts/0 -b 250000
(open /dev/pts/0
at 250000 bps)
TX: my data sent at 112500
bps and each key press in minicom
at Octo4a
logs 115200
RX: printer sends every few sec some msg at 250000
Trying to run klippy.py
:
python ./klippy/klippy.py printer.cfg -l klippy.log
TX: something is sent and looks like 250000
but Octo4a
log constantly switches between 115200
and 250000
RX: mcu replies at 250000
but feels at lower rate and klippy.log
: mcu 'mcu': Timeout on connect
I am trying with ender 3 v2 and my phone also doesn't have drivers so using octo4a. octo4a detects printer, I check with thermux it is pts/0 chmod etc. are done, printer config is set but in my case klipper also cannot connect.
I checked klipper log and looks about same.
Okay I got it to work. I set firmware baud rate to 115200 and klipper to 115200 as well. [mcu] serial: /dev/pts/0 baud: 115200
I did a reflash so I am not sure if it worked because of this or re-flash. In any case this is how I solved it.
Thanks @dsafak, I tried to debug it and found something that seems as a problem in Octo4a, created issue there. Switching baudrate seems as good workaround that worked for me too.
I think I have the same communication problem with Octo4a and my SKR2, I tried changing the printer.cfg baudrate to 115200 as you said. Which communication interface did you use to make menuconfig for 115200 bauds? Will it work over the same usb cable?
The flashing procedure doesn't work from Android, so I connected to PC, on PC in terminal run all the ’make menuconfig’ commands to configure, build and flash printer, and then went back to Android and it worked.
I appreciate the fast response! To flash the board I used a Raspberry Pi 4 with klipper working and selected communication interface "USB on PA11/PA12" on the make menuconfig. Octo4a is recognizing the board as "stm32f429", but I tried all of the available drivers and got no response from klipperscreen on the phone. Also, I gave permission 'sudo chmod 777 /home/android/octo4a/serialpipe' from ssh into the phone. What should I check? Did you flash the board selecting Serial or Uart communication interface?
Thanks for your work!
It is my first try with klipper, I was able to connect from PC, run klipper and control printer from OctoPrint (connected to
/tmp/printer
)Now I'm trying to run it from Nexus 10, installed LineageOS 13 (Android 6.0.1). Octo4a 1.1.2 detects printer (but OctoPrint's installation is corrupted)
/dev/bus/usb/002/002
/data/data/com.octo4a/files/serialpipe
points to/dev/pts/2
in
klippy.log
I get following log. Any ideas are welcome, thanks!