Mech Rev D issues - Githubissues

dHutchings commented 7 years ago

[x] Pillar Assy Drawing needs correct label: 2x washer -> 3x washer
[x] Pendulum Drawing: note about filing washer down to .022"
[x] 5 washers between pendulum links, not 4
[x] Add final dimmension to bearing_offset drawing
[x] Mounting holes for battery holder are 2.266" apart.. either the part itself or the base plate is messedup
[x] The base plate has the wrong diameter holes for the battery holder: should be 8-32 (tapped or clearance?)
[x] Look carefully at the plate mounting options... may be best to put it into tapped holes.
[x] add a second washer between the bearing_offset and the pillar.
[x] add material notes to every drawing

dHutchings commented 7 years ago

[x] add holes for zipties to pillar, for wire management. 1/8" will do fine for small zipties.

dHutchings commented 7 years ago

[x] Move battery holder so it is no more than 0.35" away from edge for USB connector

dHutchings / double_pendulum