Read this, it's important! NEW CURA DEVELOPMENT IS HAPPENING AT https://github.com/Ultimaker/Cura, this is the Cura 15.04 archive. Cura 2.1 and newer is on the Ultimaker github.
Homing Z0 for some reason is reversed when I use;
G28 X0 Y0
G28 Z0
Z axis goes other way and table crashes the bottom
I didn't have this issue with previous version, by only using G28 solves this issue.
After I save g-code to SD card, notification bar appears but there is nothing written on it and no safe remove etc.
After print reaches few layers, z axis raises for no reason and crashes the print thus destroys it.
!!! By saying all that, I know that there is nothing wrong with my printer, I just printed couple of parts with older version few hours ago. Please check these issues, thanks for your attention.
There are lost of issues with this update;
!!! By saying all that, I know that there is nothing wrong with my printer, I just printed couple of parts with older version few hours ago. Please check these issues, thanks for your attention.