Ewelink touch double working

danimtb / sonoff-danimtb

Alternative firmware for Itead Sonoff (ESP8266/ESP8285 based) devices to use them in Home Assistant

12 stars 3 forks source link

Ewelink touch double working #26

Closed lasote closed 6 years ago

lasote commented 6 years ago

Added support for a second relay/second button
Added pinout for the ewelink touch: web here bought here

Note that the 3.3 and GND are also in the connector, you it's only needed to solder 3 cables, tx, rx and gpi0, and probably gpi0 is also out there, because it is the left button.

Changed web admin interface to be able to fill second relay mqtt commands:

It can be easily extended to the three button one, not very very clean, but good enough I think.

danimtb commented 6 years ago

Hi @lasote!

Thanks you so much for adding support for this device! I would have to make some checks myself for next release and perform some tiny changes by myself.

I'll merge this and make the changes for the next release! Thanks 😄