search

danorder / All-In-One-V400-SR-Official-Klipper-

SR/V400 Klipper (Follows spec and, OFFICIAL Klipper docs or OFFICIAL devices setup instructions)
https://www.klipper3d.org/Sponsors.html
GNU General Public License v3.0
34 stars 5 forks source link

SUPER RACER - Calibrate macro does not complete calibration steps #9

Open seekis opened 1 year ago

seekis commented 1 year ago

Enstop calibration starts, but I get a Unknown command:"SET_PIN"error after each re-home. Firmware reboots and console shows Running Delta_calibration and then Delta_calibration complete, but does not do the calibration. Also does not do bed_mesh calibration.

danorder commented 1 year ago

This sounds related to your other problem. namely it doesn't have the variables file or know the location of it. basically if calibrate has a issue it'll end or do nothing to avoid. a endless loop. but, i'll check the code i may have a oversite on the error messages or lack of in this case.

andreamassaro9 commented 1 year ago

@danorder I have the same problem on Flsun SR with version 3 and main branch (the error is in backend.cfg, changing only this file all works well). With the version 2.5, that I'm actually using, it works like a charm.

danorder commented 1 year ago

Which linux device is this on, so i can check a few. I may need to add a 4th option, for file dirs. Older versions of installs have a symlink to the old directory which could be it, since the sr is just pins file. or i may just be overlooking something on the sr. This is beta state until i flip over to the sr whch should be quite soon, but, i shall check configs on a "clean " install again, since its possible my variables file has all the triggers so im not seeing this behavior. again, its easier to p.m me on fb / troubleshoot this usually leads to quicker solutions / bug finding, Other notes., make sure you have the latest files. since ive been changing / debugging a bit this week, The file is bascialy a backup off my current printer, so this behavior is a bit strange.

On Sat, Sep 23, 2023 at 11:26 AM andreamassaro9 @.***> wrote:

@danorder https://github.com/danorder I have the same problem on Flsun SR with version 3 and main branch (the error is in backend, changing only this file all works well). With the version 2.5, that I'm actually using, it works like a charm.

— Reply to this email directly, view it on GitHub https://github.com/danorder/All-In-One-V400-SR-Official-Klipper-/issues/9#issuecomment-1732382108, or unsubscribe https://github.com/notifications/unsubscribe-auth/AR4KIEFTWK4IQ6RM5VT2AIDX34SULANCNFSM6AAAAAA45G6GPE . You are receiving this because you were mentioned.Message ID: @.*** com>