Open GoogleCodeExporter opened 9 years ago
GoogleCodeExporter
commented
9 years ago I'm trying to mount via SSH, but I got this:
# mount /dev/usbdev1.1 /usb -t ntfs
mount: mounting /dev/usbdev1.1 on /usb failed: No such device
Original comment by betoneto.tbo@gmail.com on 2 Jan 2011 at 5:02
GoogleCodeExporter
commented
9 years ago Please, close this thread.
There was a hardware component crashed. Now everything is ok.Original comment by betoneto.tbo@gmail.com on 21 Jan 2011 at 5:21
GoogleCodeExporter
commented
9 years ago Same problem with a Kingston Datraveller 4GB SD Card
When i unplug and then plug it again it works but do not when turning off and
then on the NAS
# dmesg
Linux version 2.6.16-gazineu (root@meupc) (gcc version 3.4.6) #56 Tue Nov 30
04:03:41 BRST 2010
CPU: FA526id(wb) [66015261] revision 1 (ARMv4)
Machine: STAR STR8100
Warning: bad configuration page, trying to continue
Ignoring unrecognised tag 0x00000000
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 8192
DMA zone: 8192 pages, LIFO batch:1
DMA32 zone: 0 pages, LIFO batch:0
Normal zone: 0 pages, LIFO batch:0
HighMem zone: 0 pages, LIFO batch:0
CPU0: D VIVT write-back cache
CPU0: I cache: 8192 bytes, associativity 2, 16 byte lines, 256 sets
CPU0: D cache: 8192 bytes, associativity 2, 16 byte lines, 256 sets
PLL clock at 250MHz
CPU clock at 250MHz
AHB clock at 125MHz
APB clock at 62MHz
Built 1 zonelists
Kernel command line:
mtdparts=m25p80:256k(boot)ro,128k(config),960k(kernel)ro,2688k(initrd)ro,4032k@0
x0000(web),4032k@0x0000(flash) root=31:03 ro rootfstype=jffs2
PID hash table entries: 256 (order: 8, 4096 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 32MB = 32MB total
Memory: 30348KB available (1804K code, 160K data, 76K init)
Calibrating delay loop... 99.73 BogoMIPS (lpj=498688)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
PCI clock at 33M
PCI: bus0: Fast back to back transfers disabled
PCI Bridge not found
PCI map irq: 00:00.00 slot 0, pin 1, irq: 0
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
str8100_led_init: <6>Registered NAS 652 led device driver.
NetWinder Floating Point Emulator V0.97 (extended precision)
JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc.
fuse init (API version 7.8)
fuse distribution version: 2.7.4
io scheduler noop registered
io scheduler cfq registered (default)
str8100_rtc.o: rtc module version 1.0.0
str8100_wdt.o: watchdog module version 1.0.1
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x78000000 (irq = 9) is a 16550A
serial8250: ttyS1 at MMIO 0x78800000 (irq = 10) is a 16550A
loop: loaded (max 8 devices)
Star NIC Driver(for Linux Kernel 2.6) - Star Semiconductor
rxring.vir_addr=0xFFC00000 rxring.phy_addr=0x00372000
txring.vir_addr=0xFFC01000 txring.phy_addr=0x00373000
Star Internal PHY
MAC Addr: 08:0a:0b:0c:0d:0e
star_nic_init_module: internal phy patch included.
star_nic_init_module: scatter/gather enabled.
STR8100 SPI: init
m25p80 spi1.0: m25p64 (8192 Kbytes)
Creating 6 MTD partitions on "m25p80":
0x00000000-0x00040000 : "BOOT"
0x00040000-0x00060000 : "CFG"
0x00060000-0x00150000 : "KERNEL"
0x00150000-0x003f0000 : "INITRD"
0x00000000-0x003f0000 : "WEB"
0x00000000-0x003f0000 : "ALL"
str8100-ehci str8100-ehci: str8100-ehci
str8100-ehci str8100-ehci: new USB bus registered, assigned bus number 1
str8100-ehci str8100-ehci: irq 24, io mem 0xcc000000
str8100-ehci str8100-ehci: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (STR8100)
str8100-ohci str8100-ohci: str8100-ohci
str8100-ohci str8100-ohci: new USB bus registered, assigned bus number 2
str8100-ohci str8100-ohci: irq 23, io mem 0xc4000000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
usbcore: registered new driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
NET: Registered protocol family 2
IP route cache hash table entries: 512 (order: -1, 2048 bytes)
TCP established hash table entries: 2048 (order: 1, 8192 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
VFS: Mounted root (jffs2 filesystem) readonly.
Freeing init memory: 76K
Reset config: NO
MAC Addr: ac:de:48:e5:05:72
eth0:star_nic_lan_open
star_nic_enable: starting patch check.
# ls /dev
console mtd5ro ptype ptyr8 rtc ttyq6 ttys0
full mtdblock0 ptypf ptyr9 tty ttyq7 ttys1
fuse mtdblock1 ptyq0 ptyra ttyS0 ttyq8 ttys2
kmem mtdblock2 ptyq1 ptyrb ttyS1 ttyq9 ttys3
kmsg mtdblock3 ptyq2 ptyrc ttyp0 ttyqa ttys4
log mtdblock4 ptyq3 ptyrd ttyp1 ttyqb ttys5
loop0 mtdblock5 ptyq4 ptyre ttyp2 ttyqc ttys6
loop1 nasleds ptyq5 ptyrf ttyp3 ttyqd ttys7
loop2 null ptyq6 ptys0 ttyp4 ttyqe ttys8
loop3 port ptyq7 ptys1 ttyp5 ttyqf ttys9
loop4 ptmx ptyq8 ptys2 ttyp6 ttyr0 ttysa
loop5 pts ptyq9 ptys3 ttyp7 ttyr1 ttysb
loop6 ptyp0 ptyqa ptys4 ttyp8 ttyr2 ttysc
loop7 ptyp1 ptyqb ptys5 ttyp9 ttyr3 ttysd
mem ptyp2 ptyqc ptys6 ttypa ttyr4 ttyse
mtd0 ptyp3 ptyqd ptys7 ttypb ttyr5 ttysf
mtd0ro ptyp4 ptyqe ptys8 ttypc ttyr6 urandom
mtd1 ptyp5 ptyqf ptys9 ttypd ttyr7 usbdev1.1
mtd1ro ptyp6 ptyr0 ptysa ttype ttyr8 usbdev2.1
mtd2 ptyp7 ptyr1 ptysb ttypf ttyr9 watchdog
mtd2ro ptyp8 ptyr2 ptysc ttyq0 ttyra zero
mtd3 ptyp9 ptyr3 ptysd ttyq1 ttyrb
mtd3ro ptypa ptyr4 ptyse ttyq2 ttyrc
mtd4 ptypb ptyr5 ptysf ttyq3 ttyrd
mtd4ro ptypc ptyr6 random ttyq4 ttyre
mtd5 ptypd ptyr7 root ttyq5 ttyrf
Original comment by dariolin...@gmail.com on 1 Feb 2012 at 1:23
Original issue reported on code.google.com by
betoneto.tbo@gmail.comon 2 Jan 2011 at 4:04