Open bm880 opened 10 months ago
Have you tried older versions?
Have you tried older versions?
good morning sir..yes i did, also p0 state is enable, PL on afterburner is set to max... but it wont go above 50% on power draw. mining with it will reach 250W... any ideas ?
I re-uploaded the latest release with some fixes, maybe this will help.
Now as few changes as possible are made to the driver (in fact, the mining cards are only switched from TCC to WDDM this is enough for 3D acceleration).
I re-uploaded the latest release with some fixes, maybe this will help.
Now as few changes as possible are made to the driver (in fact, the mining cards are only switched from TCC to WDDM this is enough for 3D acceleration).
hi there! still facing the same issue, i have 2 CMP 90 HX and both wont work with the patch... all other mining card works great..
Maybe it somehow depends on PCI-E lines... on GPU-Z screenshot I see x4
Try this https://mega.nz/file/mJNihByZ#COVUYp3QNhtXT4TEHWcNWQqsx9oE5ctXBESq4LD_--E Password : VERSUSID
This is a driver from a user from the LTT forum
Installation: https://www.youtube.com/watch?v=YJ62a98FMXA
Hello! just tested this modded drivers and did not work, card isn't recognizing properly... yours and VersusID patches works flawlessly in all my other mining cards, except the CMP ones.
As I can see your card is using only x4 PCI-E lines. This severely limits performance.
For example, P106-100 uses x16 lines.
Being on an x4 link doesn't limit power consumption. The 3080 (same GA102 die) works fine over thunderbolt with effectively less than 4x link. It loses 10-20% performance vs x16 link, but doesn't power limit like what @bm880 showed.
Being on an x4 link doesn't limit power consumption. The 3080 (same GA102 die) works fine over thunderbolt with effectively less than 4x link. It loses 10-20% performance vs x16 link, but doesn't power limit like what @bm880 showed.
thats my point.. it is a software issue that is capping power draw, and not a hardware limitation .
then can we do shunt mod to bypass the software limitation?
using the latest patch on CMP 90 HX, limiting power draw in 120W, resulting in a very low fps.
using the same patch on P104 models, work flawlessly. Any help?