Closed Hermann-SW closed 2 years ago
Hello,
I've removed libwxgtk3.0-dev from the latest release instructions. Apologies for the trouble and thank you for using the AppImage!
Thanks, and thanks for the new appimage. I used 32bit 2.3.3 appimage for some time, but had to open vncviewer session into a 32bit PiOS since my Pi400 runs 64bit PiOS. Now I use the latest PrusaSlicer with freecad on my Pi400 main computer ! https://forum.prusaprinters.org/forum/prusaslicer/prusaslicer-v2-4-1-released/#post-592573
Description of the issue There is no installation candidate for "libwxgtk3.0-dev" on latest 64bit Raspberry PiOS, readme apt-get fails.
Hardware environment and OS that is being used to run PrusaSlicer-ARM.AppImage
Steps to reproduce the reported issue (if applicable) "sudo apt-get install ..." fails:
Screenshots (if applicable)
Fix is simply removing last package from the apt-get command, "PrusaSlicer-version_2.4.1-aarch64.AppImage" runs fine on 64bit PiOS then.