Required: Please include a ZIP file cAfter 2 or 3 layers the extruder motor of my Anycubic I3 Mega S stops working with TMC 2208.
Once installed the firmware, i had to reverse the extruder motor's pin to make it working correctly.
I tried to mash calibrating the printer different times, i checked the Vref of the drivers, i tried to swap the drivers, and i tried lowering the plate manually but the motor keeps loosing steps and than it stops working and i need to reboot the printer to make it work again.
I tried extruding filament with the built-in function and it work properly.
I followed the guide, i sent those commands after installing the firmware:
M502
M500
M92 E384
M203 E30
M204 R1500.00
M500
I calibrated the plate manually, before using the "mash calibration" function but it still doesn't work.
I tried to reduce print speed at 40 mm/s but it still stops working.
Those are the driver i'm using: https://www.amazon.it/dp/B086MYZHD9?psc=1&ref=ppx_yo2ov_dt_b_product_details
I tried to update the firmware to marlin V2 but it has the same error. During a print i noticed that the motor became more noisy for 2 seconds and than it has stopped working again
I tried to sent the command G26 C H200 P5 R25 Q4.2 Z4. It moves the extruder and the plate but it doesn't extrude. When it starts, the stepper looses steps and than it just stops working
Bug Description
My Configurations
Required: Please include a ZIP file cAfter 2 or 3 layers the extruder motor of my Anycubic I3 Mega S stops working with TMC 2208. Once installed the firmware, i had to reverse the extruder motor's pin to make it working correctly. I tried to mash calibrating the printer different times, i checked the Vref of the drivers, i tried to swap the drivers, and i tried lowering the plate manually but the motor keeps loosing steps and than it stops working and i need to reboot the printer to make it work again. I tried extruding filament with the built-in function and it work properly. I followed the guide, i sent those commands after installing the firmware:
M502 M500 M92 E384 M203 E30 M204 R1500.00 M500 I calibrated the plate manually, before using the "mash calibration" function but it still doesn't work. I tried to reduce print speed at 40 mm/s but it still stops working. Those are the driver i'm using: https://www.amazon.it/dp/B086MYZHD9?psc=1&ref=ppx_yo2ov_dt_b_product_details
I tried to update the firmware to marlin V2 but it has the same error. During a print i noticed that the motor became more noisy for 2 seconds and than it has stopped working again
I tried to sent the command G26 C H200 P5 R25 Q4.2 Z4. It moves the extruder and the plate but it doesn't extrude. When it starts, the stepper looses steps and than it just stops working
Is 0.85 correct for the Vref of all drivers?