search

dc42 / PanelDue

Firmware for TFT control panel for Duet electronics
40 stars 25 forks source link

Adjusting Tool Flow Rate is Not Consistent With the Tool that the Change was Made to #19

Closed bmalcheski closed 6 years ago

bmalcheski commented 7 years ago

This is best described with pictures which I have uploaded.

In "Panel 1" I was attempting to adjust the flowrate of Tool 3 to 99%. But it appears that either the value is just displayed in the wrong spot or that the change is applied to the wrong tool.

I then tried to change Tool 3 to 100% and get the result in "Panel 2." Again, the adjustment being applied to the wrong tool or the new value displayed in the wrong position.

I then adjusted Tool 1 to 100% and got the result in "Panel 3." I noticed this bug while in the middle of a large print so I did not want to do too much messing around but could do some more trouble shooting if necessary.

Panel 1 panel 1

Panel 2 panel 2

Panel 3 panel 3

dc42 commented 6 years ago

This is believed fixed in the latest beta from the PanelDueFirmware repository. If you don't think it is fixed in that beta, please create a new issue in that repository.