In a few spots, signal traces get rather close to where the display mounting hex nuts are placed. Some effort should be made to increase the clearance around these spots, to reduce the likelihood of an assembly mishap scratching an important trace.
This can be done by either increasing trace clearance directly, or moving affected traces to the other side of the board.
In a few spots, signal traces get rather close to where the display mounting hex nuts are placed. Some effort should be made to increase the clearance around these spots, to reduce the likelihood of an assembly mishap scratching an important trace.
This can be done by either increasing trace clearance directly, or moving affected traces to the other side of the board.